Reset and External Clock In
Connect an external LVI to pad
when supplying external 1.25V so
that PORST is asserted until
exterbal 1.25V supply is at
10.0K Bi Directional reset
Active reset drive (high / low)
for any periperhals that need to
be reset when MCU is in reset
The Reset pad on Calypso is in the VDD_HV_A domain which can be run from either 3.3V or 5V
(selected by the VDD_HV_A and PER_HVA jumpers)
To maintian brightness on the LED's irrespective of the voltage setting, the LED's are
powered from constant 3.3V, grounded via the reset line.
MCU-RSTx 5,7
RST-OUTx 12
D
C
B
A
JTAG Standard 14-pin Connector
Note TCLK needs to be pulled down to allow exit from STANDBY in some corner cases
Automotive Microcontroller
Reset Circuitry & External Clock In
Friday, February 12, 2016
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.