NXP Semiconductors UM11483 - Azurewave AW-CM358-Usd Module; Recommended Antenna Part; Supported I;O Signal Level; Supported RF Standard

NXP Semiconductors
UM11483
Getting Started with NXP Wireless Modules for i.MX 8M-Quad Platforms
UM11483 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2020. All rights reserved.
User manual Rev. 1 — 28 September 2020
21 / 39
4.1.2.4 Supported Wi-Fi features
AW-CM358-uSD and AW-CM358MA modules share the same Wi-Fi feature set. Please
refer to Section 4.1.1.3 "Wi-Fi features".
Note: Azurewave AW-CM358-uSD supports both Wi-Fi and Bluetooth RF standards.
With the combination of platform i.MX 8M Quad and AW-CM358-uSD module, since i.MX
8M Quad EVK did not define the FFC connector for Bluetooth, only Wi-Fi is supported.
4.1.2.5 Azurewave AW-CM358-uSD Wi-Fi module interface
Figure 14. AzureWave AW-CM358-uSD module interface
4.1.2.6 Azurewave AW-CM358-uSD module jumpers and power supply
This section provides the jumper settings to configure the module with 1.8V SDIO voltage
level for Wi-Fi. Connect the jumper J2 between the 1 and 2 header pins to select the
SDIO voltage source and connect the J4 jumper between the 1 and 2 header pins for
1.8V SDIO voltage as shown in Figure 15.