Oakton pH 110 - P1.0: Unit Configuration

Instruction Manual CyberScan pH 11 / 110
33
9.2 P1.0 : Unit Configuration
This subgroup program allows customising the meter to
your specific needs. You can program the meter to:
1. Select READY function ON or OFF (pH 110
allows you an additional feature of switching the
AUTO HOLD function ON or OFF)
2. Select between 2 buffer options (4 buffer
options for pH 110)
3. Select the number of pH calibration points
4. Select between °C and °F units for temperature
readings (for pH 110 meter only)
Figure 29 on the right shows the setup sequence for
this program subgroup.
The following 3 pages explain each of the program in
detail.
Figure 29: Setup sequence for
unit confi
g
uration
SETUP
cof
p 1.0
SETUP
READY
ON
p 1.1
SETUP
3 p
p 1.3
SETUP
usa
p 1.2
°C
SETUP
c
p 1.4
ENTER
HOLD
ENTER
HOLD
ENTER
HOLD
ENTER
HOLD