Instruction Manual CyberScan pH 11 / 110
53
10.3.1 Buttons & Check-Box
• Enable Connection - Click this button to enable communication between
meter and computer.
• Clear Readings - To clear all data and start all over again.
• Save Readings - To save all data displayed in either *.dat or *.txt format.
• Time Stamp - To include Time and Date stamp when collecting the data.
Time and date information comes from the computer.
Figure 56: Under File Menu setting, you can change various parameters. Under ABOUT menu, details of
Eutech Instruments' contact information, email address and updates are shown.
10.3.2 Menu
• Communication Settings - To set communication port number, baud rate
speed, parity and stop bits protocol.
• Open - To open previously saved data file.
• Save - To save current data captured.
• Save As - To save current data set in another format such as *.dat or
*.txt.
To Next Page
Loading...
