Oce 7050 - Making copies using manual roll (optional)

Copy jobs 15
▼
Making copies using manual roll (optional)
1
Press the copy material selection button to toggle between paper or film.
Attention:
Select the appropriate copy material to avoid flawed copies. All
materials (except for film) should be copied with the copy material
selection set to ‘paper’. Only select the setting ‘film’ if you make copies on
polyester film
2
Océ 7051 only: Select the desired number of copies by pressing the ‘+’ or ‘-’
button on the operating panel (see figure 5).
Note:
Changing the copy quantity can be done at all times. When you make a
mistake you simply press the correction button to correct the copy quantity.
[5] Setting more than one copy using the ‘+’ or ‘-’ button
3
Feed the original centrally and face down into the original feed table in
accordance with the guidelines (see figure 6 on page 16).
Note:
The original is aligned in the nip of the rollers. By inserting the material
with an amount of slack, the leading edge is aligned in the nip. A delay between
insertion of the material and the start of the transport ensures proper
alignment.
stop+-
correction
C
darker
paperpath
add toner
2
4
Océ 7051