6.DRIVE TRAIN
6-
REAR PROPELLER SHAFT
Removal
Place vehicle on PARK position and
select 4WD.
Loosen the left rear wheel nut.
Install a jack stand under the frame to lift
the rear of vehicle off the ground until the
shock absorber is fully extended.
Remove the left rear wheel.
Remove the propeller shaft bolts on
engine side.
Remove propeller shaft bolts on rear
differential side.
Remove the rear propeller shaft
Inspection
Inspect the propeller shaft for wear or damage. If any defects are found, replace the propeller shaft
with new one.
Check if U-joint moves freely in all direction.
Check bellows for holes or brittleness.
Installation
Installation is the reverse of removal procedure. Ensure tighten the bolts to the specified torque.
Bolt of rear propeller shaft flange
To Next Page
Loading...
