8. BRAKES SYSTEM
9-3
BRAKE FLUID REPLACMENT
1. Place the vehicle horizontally，Four wheels off the ground，Remove the tire
2. Remove the oil cap from the oil pump，Use a needle to pump out the old brake fluid，
pump in fresh brake fluid.
3. Loosen the dustproof leather cap of the exhaust valve on one of the Calipers, insert
the exhaust valve at one end of the hose, and introduce an oil storage container at
the other end.
4. Loosen the exhaust valve and press the brake pedal until the old brake fluid is
completely eliminated and the new brake fluid flows out.
5. Tighten the exhaust valve and press the brake pedal deeply several times. Make sure
that the brake pedal is pressed completely when you press it, and lift it quickly when
you release the brake pedal，After a number of times, the gas valve easily open, so that the oil
along the hose flow into the oil storage container, to eliminate the brake pedal tension，Tighten the
exhaust valve again, press the foot brake pedal deeply, and press the pedal to release the Exhaust
Valve; repeat several times until the exhaust brake fluid is free of bubbles.
6. Complete the other three calipers according to the above method.
To Next Page
Loading...
