9. BRAKES SYSTEM
9-5
(4). When replacing brake pad, replace the whole set, otherwise the braking performance will
be adversely affected.
(5). After changing the brake pad, press the brake pedal several times to check whether
the brake is normal, and then check whether there is any change in the amount of
brake fluid.
Brake disc maintenance
Disassembly
1.Remove the tyres.
2.Remove the calipers and the drive plate.
3.Remove the disc brake from the drive disc
Check
Check the brake disc for cracks or damage and measure the thickness with a micrometer. If
you find any damage or thickness below the service limit, please replace the new brake disc.
Minimum limit thickness of front brake disc: 3.5 mm.
Minimum limit thickness of rear brake disc: 3.0 mm.
Use a scale to measure warpage，If warping exceeds the use limit, replace with a new brake
disc.
Maximum warp of brake disc: 0.3 mm.
Assembly and assembly
Assemble and reassemble brake discs in reverse order of disassembly and disassembly， Note
the following points：
1.Mount the disk to the drive with the letters facing out.
2.Make sure the disc brake pads are clean and free of any greasy substances.
3.The fastening moment of disc brake fixing bolt is 26N.M.
To Next Page
Loading...
