ODES UTV Desertcross 1000cc-3 - Removal and installation of instrumentation

10. ELECTRICAL SYSTEM
10-
5
Removal and Installation of Electric Top
1、Box raised。
1、Disconnect the electric ceiling。
2、Disassemble (1, open pin ;2, upper fixed pin ;3, open pin ;
4, lower fixed pin ;5, electric top) in sequence as shown.
3、The resistance value of electric top resistor can be
detected by using ohmmeter. The resistance is
infinite or the electric top can be replaced by 0
Removal and Installation of Electric Top Switch
1、Disconnect electric top switch plug-in。
2、Remove the electric top switch from the dashboard
3、ignition switch terminals, if not meet the technical
requirements to replace the switch;
Removal and installation of instrumentation
1、Remove the positive and negative electrodes of the battery;
2、Use appropriate tools to remove the back of the instrument table, and then remove the
instrument base from the instrument table;
3、 Disconnect instrument plug。
Instrument Display Function Information