When INTERVAL is selected, set the time interval using the numeric keypad.
Settings of 1 to 3600 seconds are available.
5.10.8 Print Calibration Data
Set the automatic Calibration Data printing functionality.
OFF = disabled
ON = enabled
5.10.9 Print Content
Enter this sub-menu to define the content of the printed data.
See details below:
Header
Set the status.
OFF = the user defined header is not printed.
ON = the user defined header is printed.
USER DEFINED TEXT
USER DEFINED TEXT
USER DEFINED TEXT
USER DEFINED TEXT
USER DEFINED TEXT
Note: The header information must be defined
using the H x “text” interface command.
(See Section 5.1.)
Date and Time
Set the status.
OFF = the time and date are not printed.
ON = the time and date are printed.
Balance ID
Set the status.
OFF = the Balance ID value is not printed.
ON = the Balance ID value is printed.
Balance Name
Set the status.
OFF = the Balance Name is not printed.
ON = the Balance Name is printed.
User Name
Set the status.
OFF = the User Name is not printed.
ON = the User Name is printed.
Application Name
Set the status.
OFF = the Application Name is not printed.
ON = the Application Name is printed.
Sample Name
Set the sample name.
OFF = the Sample Name is not printed.
ON = the Sample Name is printed.
Batch ID
Set the batch ID
OFF = the Batch ID is not printed.
ON = the Batch ID is printed.
Sample ID
Set the sample ID
OFF = the Sample ID is not printed.
ON = the Sample ID is printed.
Result
Set the status.
OFF = the displayed reading is not printed.
ON = the displayed reading is printed.
NUMERIC ONLY = only the numeric portion of
the displayed reading is printed.
Gross
Set the status.
OFF = the gross weight is not printed.
ON = the gross weight is printed.
Application Name: XXXXXXXXXXXX
Sample Name: XXXXXXXXXXXX
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
