Ohmeda Biox 3700 - Preoperative Checklist; Oximeter Visual and Functional Inspection

1118-301
PREOPERATIVE CHECKLIST
Perform the following tests daily to assure proper operation of the ^
oximeter. Do NOT use the oximeter-if it fails any test. Remove it from
use until the situation has been evaluated, and the product repaired and
checked for correct operation.
WARNING FAILURE OF OPERATION: If the oximeter
fails to respond as described, do NOT use
it until the situation has been corrected
by qualified personnel.
OXIMETER
VISUAL INSPECTION
1. Inspect the oximeter case for damage.
2. Ensure the display windows are clean. (See page 83)
FUNCTIONAL INSPECTION
1. Connect a probe to the oximeter. Attach the probe to either finger
2.
3.
4.
Turn the oximeter on. Verify that the oximeter disolavs "OHMFnA-RTnY
00 REVISION: X SYSTEM CHEcl IN PROCESS" "riV^ d^agnos^c* ^
seir-test. Verify that the Status Message "SYSTEM OPERATIONAL"
appears on the Graphic Display after the diagnostic self-test.
Adjust the displays with the Viewing Angle Thumbwheel Adjustment if
necessary. J
^H£y that high and low Sa02 and pulse rate alarm limits and read
ings appear on the Digital Display.
Verify that the Patient Alarms are functional. Set the high and low
Sa02 and pulse rate alarm limits beyond the patient readings. Ensure
the alarm tone sounds, and the violated alarm limit and reading
flashes on the Digital Display.
~ 1* " 01/27/86
/^\