Ohmeda Biox 3700 - Set up

1118-301
SET UP
II. Connecting and disconnecting the Probe:
CAUTION
CONNECTING:
Use ONLY the probes supplied for this model
of oximeter. Check the Identification Number/
Serial Number Tag (A) which is located on the
cable near the connector. The model number must
read: MOD 8122-OOX or MOD 8121-OOX (X represents
a digit from 1 through 5).
* Insert the probe plug into the probe connector until an
audible "click" is heard.
DISCONNECTING:
* Push down on the connector release button and pull the probe
plug away from the connector.
CAUTION Do NOT apply tension to the probe cable.
- 36 -
01/27/86
'^S
^k