Oki 182 - Page 120

MU82/183-----------------------------------
Printer initialization
This is the sequence transmitted to the printer at the start
of priYotirog.
P""'ir.ter initializatiorl fl..t'l'"lcticlYI cClde seql..lence is cllrreYltly Dh
Enter I'C
II
to change,
or press (RETURN) to leave e'Yochanged.
-
Enter "(" to change and you'll see the following display:
You can erlter a value if', ASCI I, decirnal, or hexadecimal
-
codes. Precede each entry with these prefixes:
ASCI I
(:AA enters ASCII AA, a single value)
Hexadecirnal
,
(,41 eYlters hexadecimal 41)
Decimal
II (lIb1 enters decimal b1)
Tel enter a sequeYlce elf characters, erlter each elYle separately,
fed lowed by (RETURN).
Press (RETURN) to leave a value unchanged.
-
Enter a period (.) arId press (RETURN) to terrniyoate a sequence
arid to elimlYlate all subsequent values.
These special character"s require hexadecimal input:
(RETURN) (····M) ,OD
Period C.) ,2E
AH (backspace: ~H) ,08
MaximUM entries for printer initialization function is 16.
Cltrrent
New
Value
Value
ODh
Now enter the code sequences to establish the default print
format. You can enter a maximum
of 16 codes:
-
<CR>
-Clear buffer (00 value remains
un-
changed)
1B
<CR>
57
<CR>
Cancel Double-width
-
00 <CR>
12
<CR>
-10 cpi
lB
<CR> Cancel Superscripts/Subscripts
54
<CR>
1 B
<CR>
-
46
<CR> Utility printing
00
<CR>
<CR>
-End of entry
104