Oki 182 - Connecting Your Computer

Ml182/183 ________________ _
CONNECTING YOUR COMPUTER
You should have either a parallel or serial interface cable to connect
your computer to your ML 182 IBM-compatible printer. Before you
connect the cable, make sure both printer and computer
power is
OFF.
Connecting a Parallel Interface
1. Insert the 36-pin plug in the appropriate receptacle toward the
right side
of the printer back.
If no frame ground
(FG) included in your interface cable, con-
nect a frame ground
wire from the computer to the frame
ground connection hole at the back
of the printer using the
setscrew attached to the printer.
-
-
.• ~
r:
Frame.
........... ~grounl\l
~.. . .•.•........ . c. on. n(;lctiorT
\ hole
- \)_ \Frame Frame.
,:.. ground ground wire
\. :;: s.etsorew
"':.::.-'
-
12