Oki 182 - Paper Loading

___________ CHAPTER 2 OPERATION
PAPER LOADING
You can load paper into the printer using several methods. If you
have a printer stand
with a paper slot, you can load paper through
the bottom
of the printer. If the printer is placed on a desk or table,
paper can be loaded from the top, like typewriter paper.
If you have the optional roll paper stand or tractor feed unit, read
the instructions
below covering how to install them and how to load
the paper.
When you use fanfold paper, adjust the distance between the
sprocket pins at the ends
of the platen correspond to the paper size.
You can adjust the platen pin
width by extending or compressing the
platen ends.
To move the platen end: Unsnap the lever, move the platen end to
the left
or right, then close the lever.
Bottom Feed Paper Loading
1 Set the printer on a slotted printer stand, carefully aligning the
slot in the stand
with the opening in the base of the printer.
2 Place the box
of paper under the printer stand.
3 Remove the access cover and
lift the column indicator bar.
4 Open the paper release lever.
23