Oki 182 - Page 66

Ml182/183 ________________________________ __
If you want to print superscript characters (characters appearing
above the normal
print line), send the ESC SO command before the
characters, symbols, or word(s)
you want printed in superscript. To
return to printing on the normal
print line, use the ESC T command.
If you
want to print subscript characters (characters appearing below
the normal print line), use the ESC 51 command before entering the
characters. To return
to printing on the normal print line, use the
ESC T command.
Superscript and subscript characters are printed in normal characters.
NOTE: Printing returns to the normal line when ESC SO is used to cancel subscript
or ESC ST is used to cancel superscript.
10 LPRINT "This is a ";
20 LPRINT CHR$(27);"S";CHR$(0);"superscript"
30 LPRINT
CHR$(27);"T";"This is a";
40 LPRINT CHR$(27);"S";CHR$(1);"subscript"
50 LPRINT
CHR$(27);"T";"This is back to normaL"
This i1:> a _ .... "._ .... _o .... ,,,.~
This is a _ub_e .... '"._
This is back to norMal.
-
-
-
-
-
-
-
-
-
-
-
54