Operating instructions > 35
ITEM FUNCTION SETTING
Multi Pass Select the printing direction
when double-height print
data exists in a line.
Bi-directional
Uni-directional
Rcv Buffer Select size of the received
buffer.
0, 2 K, 32 K, 64 K
Print Suppress
Effective
Set whether to enable or
disable a print suppress
setup command.
Yes
No
Auto LF Select whether to perform
auto LF operation or not
upon receiving a CR code.
Yes
No
Auto CR
*IBM PPR only
Select whether to perform
auto CR operation upon
receiving a carriage return
command.
Yes
No
SI Select Pitch
(10CPI)
*IBM PPR/AGM only
Set how to handle an SI
command received in 10
CPI mode.
15 CPI
17.1 CPI
SI Select Pitch
(12CPI)
*IBM PPR/AGM only
Set how to handle an SI
command received in 12
CPI mode.
12 CPI
20 CPI
Reset Inhibit Set whether to enable or
disable an initial command.
No
Yes
Impact Mode Select print mode on power
on.
(This item is referred to
on initialisation only by
I-PRIME or power on but
not by an initialisation
command.)
Normal
Quiet
Hi Copy
Print Direction
Command
Select the validity of a one-
way print setup command.
Valid
Invalid
Power Saving Select whether to validate
or invalidate the power save
mode.
Enable
Disable
To Next Page
Loading...
