OkiLAN 8100e Network User’s Guide
Troubleshooting - 134
Troubleshooting
The network addresses used in this manual are shown for example
only. Network addresses used in your installation must be
generated from your own network.
Self-diagnostic test
Printer does not print.
Ensure the printer emulation is set to PS (if available) or
Automatic.
NG is printed in the Self-diagnostic test.
Confirm that the NIC is installed correctly in models that require an
optional NIC card and turn the printer off and on again.
Ensure the network cable is correctly connected and connect to a
different network segment, rerun the test and see if this cures the
fault.
EEPROM Check registers NG.
Confirm that the NIC is installed correctly and turn the printer off
and on again.
Initialize the NIC.
TCP/IP
Printer cannot find the network interface card.
Turn the printer off and on again.
Confirm the network interface is enabled on the printer.
Check there is a response to the interface card command.
Check the network cable is correctly connected.
To Next Page
Loading...
Need help?
General
