OkiLAN 8100e Network User’s Guide
Troubleshooting - 139
NetBEUI
The network interface card is not identified.
Turn the printer off and on again.
Check the network cable is correctly connected.
Change the cable and try again.
Check Microsoft network client and NetBEUI have been added to
the network section of the control panel.
Check the NetBEUI protocol is set to Enable.
Check the factory setting of the workgroup name is PrintServer and
the computer name is ML+ the last six digits of the MAC address.
Check the computer name of the NIC is different from the
computer name on the network.
Error writing to Prn1.
Check the printer is online.
If there is an error message indicating the paper has run out, add
more paper and cancel the error.
Check whether another user is printing. Print after the other user
has finished.
To Next Page
Loading...
Need help?
General
