Oki C110 - Cleaning the Print Head Window

Cleaning the Printer6-8
4 Slowly insert the imaging car-
tridge vertically, and then push it
slightly down toward you to fin
-
ish reinstalling the imaging car-
tridge.
5 Carefully close the top cover.
Cleaning the Print Head Window
1 Use either operation described below to switch the printer to Print Head
Cleanup mode.
z Hold down the Rotate Toner key for 5 to 10 seconds.
z On the Panel tab of the Remote Panel Utility, click the P/H Clean Up
button.
" The printer enters Print Head Cleanup mode, and the magenta
toner indicator lights up.
" It is not possible to exit Print Head Cleanup mode before the oper-
ation is finished (even if the Cancel key is pressed).
If the printer has incorrectly been switched to Print Head Cleanup
mode, perform steps 2 through 4, then steps 10 through 14 (skip-
ping steps 5 through 9) to exit Print Head Cleanup mode.