Mac OS X > 45
2. Click Add….
3. Click the IP Printer button.
4. From the Protocol menu, choose Line Printer Daemon – LPD.
5. Enter the printer’s IP address in Address.
To find the printer's IP address, you can print a configuration page from the printer's
operator panel. Refer to “Configuration settings” on page 7.
6. Check the correct PPD file for your printer is selected in the Print Using menu.
7. Click Add....
8. You will be prompted to configure any additional printer hardware options. If your
printer has options such as second tray, switch on the relevant options.
9. Click Continue.
10. Quit Printer Setup Utility.
P
ANTHER
(10.3)
Rendezvous
If you have not already done so, run the Oki software installer before following the steps below.
1. Start the Printer Setup Utility.
This is located in the Applications > Utilities folder.
2. Click Add....
3. From the pop-up menu, choose Rendezvous.
4. Select the printer you wish to connect to.
5. Click Add.
6. Click the Printer Setup Utility menu, and choose Quit Printer Setup Utility.
After adding the printer, you should configure printer hardware options. Refer to
“Configuring printer hardware options” on page 47.
NOTE
If your printer is already listed, your Mac may already have discovered the
printer before you installed the Oki software. In this case, the printer may be
using the incorrect PPD file or may not have the correct hardware options
configured. You should delete the printer, quit Printer Setup Utility, and re-
launch the utility before continuing.