- 21 -
Preparing Your Printer
1
1. Setup
Turning On the Power
1
Plug the AC cord (1) into the AC power
socket of your printer.
1
2 Plug the AC cord into the electric socket.
3 Hold down the power switch (2) for
about 1 second to turn on the power.
2
The Power switch LED indicator lights up when
the printer turns on.
The message “Ready To Print” is displayed in
the operator panel once printer is ready.
Turning Off the Power
1
Hold down the power switch (1) for
about a second.
The message “Shutting down Please wait.
Printer will turn off automatically” appears
in the operator panel, and the power switch
indicator blinks every 1 second. Then the printer
turns off automatically and the power switch
indicator goes out.
Note
● It may take about 5 minutes to turn off the power.
Wait until it turns off.
● Holding down the power switch for more than 5
seconds turns off printer forcibly. Only perform
this procedure when a problem occurs. For printer
problems, refer to “Other Issues” P.86.
1
When the Printer is Not Used for a
Long Time
When the printer is not used for a long time due
to consecutive holidays or when on vacation, or
when changing or attaching parts in repair or
maintenance, unplug the AC cord.
Memo
● The printer will not be functionally impaired even if left
unplugged for a long time (more than 4 weeks).
To Next Page
Loading...
Need help?
General
