- 25 -
2. Setup
• If you draw the cassette with the printer power on, the paper size, paper type, and paper thickness of the tray
are sometimes displayed on the panel.
If you change paper, change the settings to the appropriate values. You can change the setting to hide the
screen. To hide the tray paper size message, select [Admin Setup] > [Panel Setup] > [Paper setup when paper
exchange] and set it to [Off].
• Make sure to match the size of paper and that on the paper size dial. Otherwise, paper size error occurs and
printing cannot be done.
• For size of paper which can be loaded either horizontal or vertical such as A4, please be careful of the direction.
3
Slide the paper guide (3) and paper stopper (4) to the size of paper to be
loaded.
4
Fan a stack of paper well, and then align the edges of the paper.
5
Load paper with the print side face down.
• Do not load paper above the " " mark (5) on the paper guide.
6
Secure the loaded paper with the paper guide.
7
Check if a size of loaded paper matches the setting of paper size dial.
• If the size of paper and that on the paper size dial do not match, paper size error occurs and printing cannot
be done.
8
Return the paper cassette to the printer.
9
If paper that cannot be selected from the sizes on the paper size dial (the dial
setting: [Other]) is loaded, set paper size to [Custom] on the operator panel
and enter the width and length of paper.
See "Printing on Custom Size Paper (Advanced Manual)".
To Next Page
Loading...
Need help?
General
