- 60 -
4. Print
• Do not load paper exceeding the [ ] mark (7) of the paper guide.
• Use paper stored in proper temperature and humidity conditions. Do not use paper that is curled or waved
because of humidity.
• Do not print on the back side of paper on which other printer has printed.
• The paper size, paper type, and paper thickness of the MP tray are sometimes displayed on the panel. You
can change the setting to hide the screen. To hide this screen, select [Admin Setup] > [Panel Setup] > [Paper
setup when paper exchange] and set it to [Off].
7
Close the paper set cover (5).
• Paper is not fed if the paper set cover is open.
If always printing on same size or type paper from the MP tray, register the paper on
the operator panel.
If printing once, proceed to the "Open the file to print, and print it by following the
procedure below".
• When a printer is in the power saving mode, press «POWER SAVE» button to restore from the mode.
• Make sure that the message "Ready To Print" is displayed in the operator panel. If the message is not
displayed, press the «ON LINE» button.
8
Press the «Fn» key.
9
Enter «9» «0» using the numeric keypad and then press the «ENTER» button.
10
When [Paper Size] is displayed, select the size of the loaded paper and then
press the «ENTER» button.
• If [Custom] is selected for [Paper Size], you need to register the custom size. For how to register the custom
size, refer to "Printing on Custom Size Paper (Advanced Manual)".
• When using envelopes, refer to "Printing on Envelopes (Advanced Manual)".
To Next Page
Loading...
Need help?
General
