3-4 Use Scan To CIFS
Send a test email to see whether Scan To CIFS is available.
Press the “Scanner” key on the operation panel.
Press the NetworkPC icon.
Select a registered profile.
Check that [Scan Ready] is displayed, and press
<Color Start> or <Mono Start>.
[Scanning] is displayed on LCD, and Scan To
CIFS is started.
Wh
en transmission is completed, [Completed] is
displayed.
Confirm that a file scanned from MC860 is saved in
a destination computer.
If the file is saved, the setup is
completed.
If not, check the settings again.
To Next Page
Loading...
