Oki ML620 - Print Quality

ML620/ML621 User’s Guide 35
Print Quality
Important!
Front panel settings for print quality and character
pitch are normally overridden by software commands.
Draft: Utility —the default
Medium quality, medium speed (380 cps)
Gothic typeface only
HSD: High Speed Draft
Lower quality, higher speed (507 cps)
Gothic typeface only
SSD: Super Speed Draft
Lowest quality, highest speed (570 cps)
Gothic typeface only
NLQ: Near Letter Quality
Highest quality, slowest speed (95 cps)
Courier or Gothic
Note: Available Print Quality settings depend on which
Character Pitch setting is selected.








There are three PRINT QUALITY indicator lights:
The sequence of lights shows which print quality
setting is active:
 SSD
 HSD
Draft
Courier
Gothic
OCR-B
( = light off,  = light on)
The default PRINT QUALITY is “DRAFT.”
To change the PRINT QUALITY press the PRINT QUALITY
key. Each time the key is pressed the light sequence
above the PRINT QUALITY key changes until all the
options have been cycled through.