Oki ML620 - Page 48

ML620/ML621 User’s Guide 48
MENU SETTINGS TABLE
Group Item Function Settings (defaults are set in bold italic)
Rear Feed
(Push)
(cont.)
Continuous Paper Top of
Form
For continuous forms, sets a TOF
in small increments.
1/12” (2.12 mm), 2/12” (4.23 mm),
3/12” (6.35 mm), 4/12” (8.47 mm),
5/12” (10.58 mm), 6/12” (12.70
mm), 7/12” (14.82 mm), 8/12”
(16.93 mm), 9/12” (19.05 mm),
10/12” (21.17 mm), 11/12” (23.28
mm), 12/12” (25.40 mm), 13/12”
(27.52 mm), User Top of Form
LF Revise (Continuous
Paper Line Feed Adjust)
For continuous feed, adjusts the
line feed to the specied amount.
–2, –1, 0, +1, +2
Centering Position Used to limit printhead travel
when printing narrow columns.
Select Mode 1 for ML620. Select
Mode 1 or Mode 2 for the ML621.
Default, Mode1, Mode2
Front Feed
(Push)
Line Spacing Change to 8 lines per inch (lpi) to
get more lines on a page.
6 LPI, 8 LPI
Form Tear-Off
5
Specify manual form paper
advancement or select a time;
when printer is idle for .5, 1 or
2 seconds, paper is advanced
from the current print position to
the tear position. When data is
received, paper is moved to its
original printing position.
Manual, 0.5 sec, 1 sec, 2 sec