Oki ML620 - Page 71

ML620/ML621 User’s Guide 71
Set the Paper Thickness lever
to match the paper being used.
Close the access cover and turn the printer back
on.
10.
11.
NOTE: Make sure that the guide is pushed to the end
of the printhead.
Move the printhead horizontally to make sure
that the ribbon is properly installed.
Turn the take-up knob in the direction of the
arrow to take up any ribbon slack.
CAUTION!
Do not turn the knob counterclockwise as the
ribbon may jam.
Make sure that the ribbon is not twisted or
damaged when it goes through the gap between
the printhead and the ribbon guide.
8.
9.