Oki N36800B - Page 123

Changing settings from the operator panel
- 123 -
Item
Factory
default
settings
Description
Near Life LED Enable Sets whether to light the «ATTENTION»
lamp when the supplies or maintenance
parts are approaching the end of service
life.
Idle display Toner Gauge Selects the information to be displayed on
the standby screen.
Panel Contrast 0 Adjusts the contrast of the display.
Value range: -10 to +10
Buzzer Setup Error Volume Off Sets the buzzer volume when an error
occurs.
Print Completion Buzzer Volume Off Sets the buzzer volume when the printing
has completed.
AirPrint Buzzer Volume
Low
Sets the volume of the AirPrint buzzer.
Card Hold Buzzer Volume Low Sets the buzzer volume when the IC card is
held.
Displayed when access control is enabled.
Time Setup
Date Format
yyyy/mm/dd
Sets the date in the format of yyyy/mm/dd.
Time Zone +9:00 Sets the GMT time zone.
Value range: -12:00 to +13:00 (in
increments of 15 minutes)
Daylight Saving Off Sets the daylight saving (daylight saving
time).
Setting method Manual
Setup
Selects how to set the time.
SNTP Server(Primary)
(Blank)
Sets the SNTP server used to set the
current date and time. Up to 64 characters
can be used.
Displayed when [Auto Setup] is selected as
the setting method.
SNTP Server(Secondary) (Blank)
Time Setting 2001/01/01
00:00:00
The time is set at factory delivery. Change
the date and time if necessary.
Displayed when [Manual Setup] is selected
as the setting method.
Power Setup Auto Power Off Auto Config Sets the operation of Auto Power Off.
Auto Setup: Auto Power Off does not work
for network (wired/wireless) connection.
Enable: Auto Power Off works regardless of
the connection method.
Disable: Auto Power Off does not work.
Tray Setup Unit of Measurement millimeter
Sets the unit of measurement for the custom
size (mm/inch).
Default Paper Size
A4
Sets the default paper size of a custom size.
Others Setup Paper Feed
Roller
Counter
Clear
MP Tray Clear Execute Clears the counter after the paper feed roller
of the MP tray is replaced.
Tray1 Clear Execute Clears the counter after the paper feed roller
Tray 1 is replaced.
Tray2 Clear Execute Clears the counter after the paper feed roller
Tray 2 is replaced.
Tray3 Clear Execute Clears the counter after the paper feed roller
Tray 3 is replaced.
Tray4 Clear Execute Clears the counter after the paper feed roller
Tray 4 is replaced.