Oki N36800B - Connecting via a wired LAN

Connecting to the PC after preparing the device
- 36 -
Connecting via a wired LAN
Connect this machine and a PC with a LAN cable to print. Connect the LAN cable, and set the IP address and
others on the operator panel.
Connecting the LAN cable
1 Prepare a LAN cable (category 5e or better, twisted pair, straight) and a hub.
2 Power off this machine.
3 Plug one end of the LAN cable into the network interface connector (LAN1) of this machine.
4 Plug the other end of LAN cable into the hub.
Then, set the network information like the IP address on this machine.
Setting the IP address, etc.(P.36)
Setting the IP address, etc.
Set values suitable for the current environment on the operator panel.
The following case is taken for example here.
(Example)
 IP address of this machine: 192.168.0.2
 Subnet mask: 255.255.255.0
 Gateway address: 192.168.0.1
When using a wireless LAN, see "
Connecting via a wireless LAN(P.41)".