Oki N36800B - Page 357

Troubleshooting
- 357 -
Cause
Solution
Reference
Settings are not insufficient to
connect.
To connect via the wireless LAN access point or the
wireless LAN router, set the wireless LAN (Infrastructure)
accordingly.
To connect a mobile device directly to this machine, set the
wireless LAN (AP mode) accordingly.
Connecting via
an access point
(Infrastructure)(
P.42)
Connecting
directly with this
machine (AP
mode)(P.53)
Network connection settings are
incorrect.
 Wireless LAN (Infrastructure) and Wireless LAN (AP
mode) cannot be enabled at the same time.
 To connect via a wireless LAN (Infrastructure), set
[Wireless(AP Mode)] to [Disable] and
[Wireless(Infrastructure)] to [Enable].
 To connect via a wireless LAN (AP mode), set
[Wireless(Infrastructure)] to [Disable] and
[Wireless(AP mode)] to [Enable].
Connecting via
a wireless
LAN(P.41)
The settings of wireless LAN
(Infrastructure) are incorrect.
If you are connected via a wireless LAN (Infrastructure),
check the infrastructure settings.
Connecting via
an access point
(Infrastructure)(
P.42)
The settings of wireless LAN (AP
mode) are incorrect.
If you are connected via a wireless LAN (AP Mode), check
the AP mode settings.
Connecting
directly with this
machine (AP
mode)(P.53)
A timeout occurs during
connection.
Connect by specifying the wireless LAN access point you
want to use from the wireless LAN access points detected
by this machine.
Connecting by
selecting a
wireless LAN
access point
from the
operator
panel(P.47)
For Windows
Cause Solution Reference
The IP address is incorrect.  Make sure the IP address of this machine matches
the one set on the PC.
 Make sure the IP address does not overlap with that
of other devices.
 If [IP Address Set] is set to [Auto], the address may
change dynamically. If the setting changes frequently,
change [IP Address Set] of this machine to [Manual],
and match the IP address of this machine with the one
set on the PC.
 Make sure the configured IP address, subnet mask
and gateway address are all correct.
 For the OKI LPR Utility, check the IP address settings
with the OKI LPR Utility.
Printing the
menu map
(configuration)(
P.86)
OKI LPR
Utility(P.278)
The WSD port is in use. When the print port does not function well with "WSD",
specify the IP address or short printer name of this machine
in the standard CP/IP port, and add the print port.
-