Connecting to the PC after preparing the device
- 45 -
8
Use either the scroll buttons or the numeric keypad to input the first 3 digits of the IP address,
and press «OK».
Likewise, input the next 3 digits, and press «OK». Press «OK» after inputting all the digits.
9
Press ▼ to select [Subnet Mask], and press «OK».
10
Input the subnet mask in the same way as the IP address. Press «OK» after inputting all the
digits.
11
Press ▼ to select [Gateway Address], and press «OK».
12
Input the gateway address in the same way as the IP address. Press «OK» after inputting all
the digits.
13
Press «ON LINE» to return to the standby screen.
4. Connecting with the wireless access point
There are three ways as follows. Usually, it is connected with the simplest WPS.
To Next Page
Loading...
