Canadian Owners:
If
you lose or damage your keys,
only a
GM
dealer can service PASS-Key@
Ill
to have
new keys made.
To
program additional keys you
will need two current driver’s keys (black in color).
You must add a step to the following procedure.
After Step
3
repeat Steps
1
through
3
with the second
current driver’s key. Then continue with Step
4.
To program the new key:
1.
Verify the new key has PK3 stamped on it.
2. Insert the ignition key in the ignition and start the
engine. If the engine will not start see your dealer
for service.
3. After the engine has started, turn the key to
OFF
and remove the key.
4.
Insert the key to be programmed and turn it to RUN
within
10
seconds
of
removing the previous key.
5.
The security message will turn
off
once the key has
been programmed. It may not be apparent that the
security message went on due to how quickly
the key is programmed.
6.
Repeat Steps
1
through
4
if
additional keys are to
be programmed.
If
you are ever driving and the security message comes
on and stays on, you will be able to restart your
engine
if
you turn it
off.
Your PASS-Key@
Ill
system,
however, is not working properly and must be serviced
by your dealer. Your vehicle is not protected by the
PASS-Key@
Ill
system at this time.
If
you lose or damage a PASS-Key@
Ill
key, see your
dealer or a locksmith who can service PASS-Key@
Ill
to
have a new key made.
2-3
1
To Next Page
Loading...
