Remote  Keyless  Entry  System 
If 
equipped, the keyless entry system operates on a 
radio  frequency subject to Federal Communications 
Commission  (FCC)  Rules  and with Industry Canada. 
This device complies with Part 
15 of the FCC Rules. 
Operation is subject to the following two conditions: 
1. 
This device may  not  cause  interference, and 
2. 
This device must accept any interference received, 
including interference that may  cause  undesired 
operation of the  device. 
This device complies with 
RSS-210 of  Industry Canada. 
Operation is subject to the following two conditions: 
1. 
This device may  not  cause  interference, and 
2. 
This device must  accept  any  interference received, 
including interference that may  cause  undesired 
operation of the  device. 
Changes  or  modifications to this system by other than 
an  authorized service facility could void authorization to 
use  this  equipment. 
At times you may notice a  decrease  in range. This is 
normal for  any  remote  keyless entry system. 
If 
the 
transmitter does not work  or 
if 
you  have  to  stand closer 
to your vehicle for  the transmitter to work, try this: 
e 
e 
e 
e 
Check the distance. You  may  be  too far from your 
vehicle. You may  need  to stand closer during 
rainy or snowy weather. 
Check the location. Other vehicles or objects may 
be blocking the signal. Take  a  few  steps to  the 
left or right, hold the transmitter higher, and 
try again. 
Check to determine 
if 
battery replacement is 
necessary. See 
"Battery  Replacement" 
under 
Remote  Keyless  Entry  System  Operation  on 
page 
2-6. 
If 
you are still having trouble, see your dealer or 
a qualified technician for service.