Memory
Seat
If your vehicle has this
feature, the controls are
located to the left of
the steering column and
are used to program
and recall the driver’s
seat settings.
Adjust the driver’s seat to the position you would like for
driving. Then press and hold memory button
1
for
more than three seconds.
A
double beep will sound
when the memory is set.
To set the seat for a second driver, follow the previous
steps, but press button
2
instead.
To recall your memory positions, your vehicle
must be in PARK
(P).
Press and release the memory
button
(1
or
2)
corresponding to the desired driving
position. The seat will move to the position previously
stored for the identified driver.
You
will hear one beep.
You can also store an exit position for each driver.
The exit position is programmed by moving the seat to
the desired exit position and then holding the EXIT
button for more than three seconds. The exit position
set will be for the most recently selected driving
position
(1
or
2).
A
double beep will sound when the
memory is set. To use EXIT, your vehicle must be
in PARK (P). Press and release the EXIT button and the
seat will move to the exit position stored for the most
recently selected driver. You will hear one beep.
To
stop recall movement of the seat at any time,
press one of the three memory buttons or one of the
power seat controls located on the outboard side of the
driver’s seat.
2-72
To Next Page
Loading...
