Before your vehicle was shipped from the factory,
it was programmed in Mode
1.
The mode to which the
vehicle was programmed may have been changed since
it left the factory. To determine the mode to which
your vehicle is programmed or to program your vehicle
to a different mode, do the following:
1.
Follow the instructions for
Entering Programming
Mode on page
2-63.
2.
Insert your spare key fully into any door key
cylinder and turn it to the unlock position.
This step is necessary to prevent accidental
programming of this feature to Mode
2.
Do
not
program this feature to Mode
2
without first
reading Mode
2
entirely. The door key cylinder
must remain in the unlock position during
Steps
2
through 4.
3.
Press the button with the horn symbol on the
remote keyless entry transmitter.
4. Count the number of chimes you hear.
The number of chimes indicates the vehicle's
curreni programmed mode.
(ii
you
ao
not
wish
io
change the current mode, you can either exit
the programming mode by following the instructions
later in this section or program the next feature
available on your vehicle.)
5.
Press the panic button to change the current mode.
6.
Press the panic button until you hear the number
of chimes corresponding to the mode selection
you want.
7.
Remove your key from the door key cylinder.
The mode you selected is now set. You can either exit
the programming mode by following the instructions
next in this section or program the next feature available
on your vehicle.
Exiting Programming
Mode
To exit programming mode, turn the key from
ACCESSORY to
OFF
and put the BCM PRGRM fuse
back into the instrument panel fuse block.
After programming a feature, you can exit the
programming mode at anytime.
Also,
if
your vehicle
is equipped with the content theft-deterrent system,
remember to arm the svstem before exitinq.
2-71
To Next Page
Loading...
