Before your vehicle was shipped from the factory,
it was programmed in Mode
4.
The mode to which the
vehicle was programmed may have been changed since
it
left the factory. To determine the mode to which
your vehicle is programmed or to program your vehicle
to a different mode, do the following:
1.
Follow the instructions for
Entering Programming
Mode on page
2-63.
2. Press UNLOCK on the power door lock switch.
3.
Count the number of chimes you hear.
The number of chimes indicates the vehicle’s
current programmed mode.
(If
you do not wish to
change the current mode, you can either exit
the programming mode by following the instructions
later in this section or program the next feature
available on your vehicle.)
4.
Press UNLOCK to change the current mode.
5.
Press UNLOCK until you hear the number of chimes
corresponding to the mode selection you want.
The mode you selected is now set. You can either exit
the programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
Remote Driver Unlock Control
This feature allows you to customize the UNLOCK
button on the remote keyless entry transmitter.
Programmable Modes
Mode
1:
Remote
All
Doors Unlock (When you press
UNLOCK on your remote keyless entry transmitter,
all doors and the liftgate will unlock.)
Mode
2:
Remote Driver’s Door Unlock Only
(When you press UNLOCK on your remote keyless
entry transmitter once, the driver’s door will unlock.
When you press UNLOCK on your remote keyless entry
transmitter again within five seconds, all doors and
the liftgate will unlock.)
Before your vehicle was shipped from the factory,
it
was programmed in Mode
2.
The mode to which the
vehicle was programmed may have been changed since
it left the factory. To determine the mode to which
your vehicle is programmed or to program your vehicle
to
a
different mode, do the following:
1.
Follow the instructions for
Entering Programming
Mode on page
2-63.
2. Press UNLOCK on the remote keyless entry
transmitter.
2-66
To Next Page
Loading...
