When to Check Power Steering Fluid
It is not necessary to regularly check power steering fluid
unless you suspect there is a leak in the system or
you hear an unusual noise.
A
fluid
loss
in this system
could indicate a problem. Have the system inspected
and repaired. See
Engine Compartment Overview
on page
5-
72
for reservoir location.
How
to
Check Power Steering Fluid
Turn the key off
,
let the engine compartment cool down,
wipe the cap and the top
of the reservoir clean, then
unscrew the cap and wipe the dipstick with a clean rag.
Replace the cap and completely tighten
it.
Then remove
the cap again and look at the fluid level on the dipstick.
When the engine compartment is hot, the level should
be at the H (hot) mark. When it’s cold, the level
should be at the
C
(cold) mark.
If
the fluid is at the
ADD mark, you should add fluid.
What to Use
To
determine what kind of fluid to use, see
Part
D:
Recommended Fluids and Lubricants on page
6-16.
Always use the proper fluid. Failure
to
use the proper
fluid can cause leaks and damage hoses and
seals.
Windshield Washer Fluid
What to Use
When you need windshield washer fluid, be sure to read
the manufacturer’s instructions before use.
If
you
will
be operating your vehicle in an area where the
temperature may fall below freezing, use a fluid that
has sufficient protection against freezing. See
Engine
Compartment Overview on page
5-12
for reservoir
location.
Adding Washer Fluid
.
--
PA
Open the cap with the
washer symbol on it.
Add washer fluid until
the tank is full.
5-38
To Next Page
Loading...
