Finding a Station
AM FM: Press this button
to
switch between AM, FM1
and FM2. The display
will
show your selection.
TUNE: Turn this knob to select radio stations.
k
SEEK
>I
:
Press the right or the left arrow
to
go to
the next or
to
the previous station and stay there.
The radio will seek only
to
stations that are
in
the
selected band and only to those with a strong signal.
k
SCAN
>I
:
Press and hold either SCAN arrow
for two seconds until SC appears on the display and
you hear a beep. The radio will go
to
a station, play
for a few seconds, then go on to the next station.
Press either SCAN arrow again to stop scanning.
To
scan preset stations, press and hold either SCAN
arrow for more than four seconds. PRESET SCAN will
appear on the display. You will hear a double beep.
The radio will go to a preset station stored on your
pushbuttons, play for a few seconds, then go on to the
next preset station. Press either SCAN arrow again
to
stop scanning presets.
The radio will scan only to stations that are in the
selected band and only
to
those with a strong signal.
Setting Preset Stations
The six numbered pushbuttons let you return
to
your
favorite stations. You can set up to
18
stations (six
AM,
six FMI and six FM2) by performing the following steps:
1.
Turn the radio on.
2. Press AM FM to select
AM,
FMI or FM2.
3.
Tune in the desired station.
4.
Press
AUTO
EQ
to
select the equalization that
best suits the type of station selected.
5.
Press and hold one of the six numbered
pushbuttons until you hear a beep. Whenever you
press that numbered pushbutton, the station
you set will return and the equalization that you
selected will also be automatically selected for
that pushbutton.
6. Repeat the steps for each pushbutton.
3-8
1
To Next Page
Loading...
