MAESTRO SMART 43
9.23 Compressor removal
Remove the b
ody (Cf. 9.2 Body removal, on p. 32).
Remove the grille (Cf. 9.5 Grille removal, on p. 33).
Remove the front panel (Cf. 9.3 Front grille removal, on p. 32). Remove
the electronic assembly housing (Cf. 9.11 Electronic assembly housing
removal, on p. 36).
Remove the upper tank (Cf. 9.8 Upper tank removal, on p. 35). Remove
the internal fan (Cf. 9.9 Internal fan removal, on p. 36). Remove the
intermediate tank assembly (Cf. 9.18 Intermediate tank assembly removal,
on p. 39).
Discharge the gas from the refrigerant circuit (Cf. 9.20 Charge/discharge
refrigerant, on p. 40).
NOTE: Before moving every individual assembly-component, ensure that
the electrical wiring and any condensate drain tubes are disconnected.
Remove the screws (1)(2) and release the right side (3).
Remove the screw and loosen the cap over the electrical connections (4).
Disconnect the wires (5).
Remove any insulation from the tubes.
Place a shield (5) to protect the device and then unsolder the tubes at the
end (A)(B).
To Next Page
Loading...
