2-16 d-Color MF 3300/3800
Replacing consumables
2
2.2
8 Close the Right Door.
9 Select [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Life] - [New Release]
- [Transfer Roller Unit], then reset the counter.
2.2.5 Replacing the Transfer Belt Unit
After the Transfer Belt Unit replacement message has appeared, printing is possible, but the printing quality
reduces. Immediately replace the Transfer Belt.
1 Turn the power of this machine off, then disconnect the power cable and interface cable.
2 Open the Front Cover.
3 Remove all of Toner Cartridge, Waste Toner Bottle, and Imaging Unit.
% For information on how to remove a Toner Cartridge, refer to page 2-4. Inclining the Toner Car-
tridge may cause toner to spill.
% For information on how to remove a Waste Toner Bottle, refer to page 2-13. Inclining the Waste
Toner Bottle may cause toner to spill.
% For information on how to remove an Imaging Unit, refer to page 2-8. Cover the removed Imaging
Unit with a cloth to keep from being affected by light.
To Next Page
Loading...
Need help?
General
