2-22 d-Color MF 3300/3800
Replacing consumables
2
2.2
5 Attach the Filter Case to the main unit.
6 Select [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Life] - [New Release]
- [Toner Filter], then reset the counter.
2.2.7 Replacing a Fusing Unit
After the Fusing Unit replacement message has appeared, printing is possible, but the printing quality re-
duces. Immediately replace the Fusing Unit.
7CAUTION
- The Fusing Unit is too hot. It may cause a burn injury; therefore, leave the Fusing Unit out for 20 minutes
or more until it reaches room temperature after turning the power off. Then, replace the Fusing Unit.
1 Turn off the power of this machine.
2 Pull the lever (1), then open the Right Door (2).
% When opening the Right Door, be sure to fold the Manual Feed Tray in advance.
To Next Page
Loading...
Need help?
General
