Olivetti d-Copia 163MF - Detaching and Refitting the Heater Lamp, Heat Roller, Fuser Thermistor, Thermal Cutout, and Press Roller

1-5-10
(2) Detaching and refitting the heater lamp, heat roller, fuser thermistor, thermal cutout, and press roller
<Procedure>
1. Remove the fuser unit (See P.1-5-8).
2. Remove the two screws and terminal.
3. Remove the heater lamp.
* Seat the heater lamp aligning its wattage
mark and welding mark faced with the cor-
rect direction and side.
Figure 1-5-13
Rating
marking
Welding side
Terminal
Screw
Screw
Heater lamp
Heater lamp
Fuser gear
Service Manual Y107330-8