Olivetti M15 Plus - Page 30

GETTING STARTED
or an unintended cable disconnection the system will
automatically be powered by the batteries. No data will be
lost.
In such a case the hard disk will
battery power) only if the hard
position ON (=1).
continue working (on
disk switch is in the
When you work in environments where the AC power is not
very reliable, we recommend as a matter of routine, that
you leave the hard disk switch in position ON (=1) if the
hard disk is needed while you are working.
SWITCHING ON - AC POWER
1. Turn the contrast control knob (21,A) to the maximum
brightness position (anti-clockwise). Maximum
brightness means minimum contrast.
2. Switch the backlight switch (21,8) into the OFF
position.
3. Switch the system on (setting the ON/OFF switch (22,A)
to position ON (=1).
The power indicator light (2J,A) (green
comes on.
WARNING - HARD DISK SWITCH
power ON)
I~ortant: After you switched ON a system with hard disk,
don't change the position of the hard disk switch (18,8).
The results may be unpredictable.
Before changing the position of the hard disk switch, save
your current work session and switch the system OFF.
J-J