Olivetti M15 Plus - Loading and Using the Customer Test

LOADING AND USING THE CUSTOMER TEST
I.portant:
If for some reason you are planning to check your diskette
drive(s) by means of the Customer Test, note the following:
When the diskette drive is tested, a message will ask you
to remove the UTILITIES diskette and to insert a formatted
diskette. This diskette must be formatted as explained in
the MS-DOS User Guide.
It is important then, in the following cases, to have
specially formatted diskettes available:
a)
When you wish to
SYSTEM CHECKOUT,
tested in turn if
drives.
select the Customer Test option:
in which case the disk drives will be
you have a system with
two disk
b) When, in TEST ONE MODULE mode, you
individual test of the disk drive(s).
select the
You should proceed as follows to start the Customer Test:
1. Check that the system is switched off.
2. Before beginning the Customer Test, we recommend that
you make the power cable connections between the AC
outlet and the computer and run the test on AC supply,
because the extensive read/write operations made during
the test are very power-consuming.
3. Activate the write-protect tag on the UTILITIES
diskette and insert the diskette in disk drive A (the
right-hand disk drive).
4. If you have a system with a hard disk switch, set this
switch to the ON position (=1).
Switch the system on (setting the ON/OFF switch (22,A)
8-4
M15 PLUS INSTALLATION AND OPERATIONS GUIDE