Olivetti M15 Plus - Multi-Character Keys

To revert to lower case mode, simply press the CAPS LOCK
key once more.
An LED indicator on the CAPS LOCK key lights up when the
alphabetic section of the keyboard is in upper case mode.
MULTI-CHARACTER KEYS
Some keys, on certain national keyboards, are capable of
entering up to five characters, depending on which key
combination
is used along with them . The illustration
(J9,A) shows which key combination accesses which character
on one of these multi-character keys (on the left is shown
a general example, on the right is shown a special key from
the Norwegian keyboard):
Each character has a corresponding key combination as
follows:
A - The key alone is pressed (unshifted)
B - Press and hold down ALT and then the key (unshifted)
C - Press and hold down SHIFT and then the key
o - Press and hold down ALT and SHIFT and then the key
E -
Press and hold down CTRL and ALT and then the key.
Note
concerning the above:
When entering one of the above combinations, press the keys
in the order shown, holding down the first while pressing
the second, and so on. Hold down the keys until the
desired action has taken effect.
The above table concerns only the alphanumeric keys and
does
not apply to the nu.eric keypad , which will be
explained later on. Dual function control keys (e.g. the
cursor keys) will be explained separately. The number key
6-2
M15 PLUS INSTALLATION AND OPERATIONS GUIDE