Olivetti M15 Plus - Page 72

SWITCHING orr, TRANSPORTING YOUR SYSTEM
If you copied the Travel utility to the operating
system diskette as described in this manual you can
type the command
a:travel (ENTER)
with the operating system diskette inserted in
drive A:.
If you copied the travel utility to the root directory
of the hard disk as described in this manual you can
type the command
\ travel (ENTER)
directly with the C) prompt on the screen . No
diskette needs to be inserted into drive A:.
NOTE: After the Travel utility has been loaded you will be
informed
in two different ways that the hard disk heads
have been parked
in a safe zone:
1. A message (42) appears on the screen to inform you
that the hard disk heads have been parked.
2. The hard disk indicator light
blinking (frequency: 0.5 Hz).
(41,C) starts
The system
keyboard.
system can
hard
disk .
will not accept any further input from the
The system .ust be switched off . Now the
be moved/transported without any risk to the
Whenever the system is switched on again, the keyboard
and system
will function normally.
8-3