128
Chapter 7
Adding Sound
Sound can be added to still pictures after you take them. You can also
change sound that has already been recorded. Recording sound takes
approx. 4 seconds for each picture.
1
Select a still picture to add sound to by using the arrow pad.
● Sound cannot be added to pictures with the mark.
2
In the top menu, select MODE MENU T PLAY T .
3
Press í to display START.
4
Point the camera microphone towards the subject, then press to
start recording.
● A bar is displayed to show the progress of recording.
Built-in microphone
● To obtain the optimum sound, the microphone should be placed no further
than 1m (3.3 ft) away from the subject.
● When a new sound is recorded, the original sound is erased.
● function is not available when the card is protected or when “ CARD
FULL” appears (indicating there is no memory left).
● Sound may not be recorded when a card has insufficient memory.
● Sound recording may also pick up camera noises (e.g. buttons clicking,
shutter movement, etc.).
● After being added, sound cannot be erased from pictures. However, you
can replace the sound with silence by doing the above steps again while
keeping quiet.
To Next Page
Loading...
