Insert the card fully with the contact area
facing towards the monitor side. Insert
until you feel it locked into place.
● Note the orientation of the card. If it is
inserted incorrectly, it may become
jammed.
Push in the card lightly to unlock it, then
pull it out.
29
Card basics (Cont.)
Chapter 1
Make sure the camera is turned off (i.e. the mode
dial is set to OFF).
Open the Card cover.
Close the cover tightly.
1
2
3
3
4
● NEVER open the card cover, eject the card, remove the batteries, or
disconnect the optional AC adapter while the camera is in use or the
camera is communicating with a computer. Doing so could destroy all
data on the card.
● Destroyed data cannot be restored.
Inserting the card
Ejecting the card
Inserting/ejecting the card
To Next Page
Loading...
