142
Chapter 8
Self-Timer Shooting
This function is useful for taking pictures that the shooter wants to be in too.
This can also be done with remote-control shooting.
1
Use a tripod to stabilize the camera.
2
In the top menu, select MODE MENU
T CAMERA T DRIVE T , then
press (in the mode,
select MODE MENU T CAMERA T
T ON, then press ).
● appears on the control panel.
3
Press the shutter button fully to start
self-timer shooting.
● The self-timer/remote control lamp on the
front of the camera lights up for approx. 10
seconds, then starts blinking. After blinking
for approx. 2 seconds, the picture is taken.
(In the mode, recording starts.)
● To stop shooting while in the mode,
press the shutter button fully again.
Self-timer/remote control lamp
Self-timer/remote control
● To stop the self-timer, press . The self-timer/remote control lamp
will turn off.
TIPS
● The self-timer mode is canceled after the picture is taken even if OFF is
selected in All Reset (P. 143).
● In the mode, the camera automatically stops shooting when it goes over
the maximum recording time for one shot.
● In the P and A/S/M modes, only single-frame shooting is possible with the
self-timer. Sequential shooting is not available.
Control panel
To Next Page
Loading...
